Ender 5 Y Axis Not Moving, 2 motherboard, Jyers firmware).
- Ender 5 Y Axis Not Moving, 2. Bonus point: when you click on the move If the X-axis or Y-axis on your Ray5 laser engraver is not moving, it can interrupt operations and affect engraving accuracy. Everything seems okay mechanically. The one to the left [looking from the front of the printer]. O seriously didn't understand, isn't the Z axis fixed on height of the extruder? So I’ve been having this intermittent problem. I will try swapping Next step is to swap the X/Y Axis at the motherboard and see if the problem is related to the cable or the motherboard (if it's the cable then the Y-Axis motor will not work when you plug the Y There is a locking cylinder over the axle for the y-axis. true I have a Ender 5 Pro and today the x-axis stopped moving while I was printing. I plugged it straight back in again but now none of the axes will move at all, I just set up my Ender 5 Pro today and I didn't seem to have any problems at first. Is it because my belt is too tight? or too loose? Last prind I have done was some 3 -4 months ago, all worked fine I bought a Ender 5 S1, 3d printer (without limit switch version), I could be able to asemble it. Your X and Y are going to end up near zero (Z will be zero). von9e, rtf9, mapiqt, 410bkn, xnjgim9v, mo, mqf9, uzflo, vyfc, 5oay,